ah yes, a little oversize so hit it with a bigger hammer. 🙂

Great day at the show. Lots of model to rival some of the big shows. Mostly locos of many gauges but only a couple at G1. Will have to do better on that next year. Some boats, a little Meccano, some jewellery for the ladies. More traders than listed on the website. Photos to follow.

Key info – the entrance is a leg of the roundabout opposite Tesco entrance, just next to Premier Inn.

On the EDMES stand Ces (club Sec) is seen holding a single piece resin printed body for the G1MRA ‘Greenly’ engine. The club display on the table in front of him had a few things like taps and dies to introduce newcomers to things engineering and also on display were engines made by two teenagers attending our Tuesday evening workshop classes.

There were a few things on this stand that apparently you put in water instead of rails. Note top right a 3D printer demonstrated by Newton Abbott club

But this one, over 6ft long provided an escape route for the passengers with things that again don’t use rails.

On the Federation stand the builder had taken the fate of the Titanic to heart though he explained it was to stiffen the hull.

more to come:

Hopefully Jason or someone from West Yeovil club is reading this and can advise…