Dog clutch for Myford ML10

[Jeremy Smith 2Participant @jeremysmith2]

I finally got my ml10 lathe up and running. I was wondering is anyone has plans or dimensions for building a dog clutch for this unit?

[Jeremy Smith 2Participant @jeremysmith2]

[Mick B1Participant @mickb1]

Well, there's a sort of dog clutch available to connect the heastock gear output shaft to the leadscrew?

[bobchaParticipant @bobcha]

A guide to the components that I made when I fitted a dog clutch to my ML10 . The inner diameter of the body and stop collar is obviously bored to fit the leadscrew. The lengths I will measure and post tomorrow if I have the time. Hope that helps.

Charlie.

[Jeremy Smith 2Participant @jeremysmith2]

Posted by bobcha on 03/03/2020 20:23:41:

A guide to the components that I made when I fitted a dog clutch to my ML10 . The inner diameter of the body and stop collar is obviously bored to fit the leadscrew. The lengths I will measure and post tomorrow if I have the time. Hope that helps.

Charlie.

That would be great. That and any pictyres would be a big help.

[bobchaParticipant @bobcha]

I have put photos in my album just click on it.

charlie.

[HopperParticipant @hopper]

Drawings are shown about three quarters of the way through this video **LINK**

[Clive HartlandParticipant @clivehartland94829]

If you do this mod, then get the graduated collar for the right hand end of the shaft. About £25 ? I have done this mod but I seldom use it unless I need to shut of gear drive.

[Author]

Posts