shopmade tool cutter grinder attachment

[celso ari schlichtingParticipant @celsoarischlichting85092]

[celso ari schlichtingParticipant @celsoarischlichting85092]

my shopmade tool cutter grinder attachment:
https://youtu.be/jWvuVNYuZ6c

greetings from Brazil
Celso Ari

[IanTParticipant @iant]

Very nice work Celso, well done – but that last bandsaw cut made me nervous…

Regards,

IanT

[SteviegtrParticipant @steviegtr]

Brilliant work.

Steve.

[EmgeeParticipant @emgee]

Smart work Celso.

Emgee

[Pete RimmerParticipant @peterimmer30576]

Teriffic work Celso, as usual. However I'd have to question the concentricity of the collet taper to the spindle OD given that you had it held in the 3-jaw. I think you might find that you have to clock the OD in a 4-jaw and cut that taper again. Even tiny amounts of concentric error show up when you're sharpening cutters etc.

[thaiguzziParticipant @thaiguzzi]

Like button pressed…

[celso ari schlichtingParticipant @celsoarischlichting85092]

Posted by IanT on 27/03/2020 22:21:54:

Very nice work Celso, well done – but that last bandsaw cut made me nervous…

Regards,

IanT

Thanks Ian. The bandsaw run slowly, there is no dange.

Regards.

Celso Ari

[celso ari schlichtingParticipant @celsoarischlichting85092]

Posted by Steviegtr on 28/03/2020 00:03:42:

Brilliant work.

Steve.

thanks Steve,

greetings from Brazil

[celso ari schlichtingParticipant @celsoarischlichting85092]

Posted by Emgee on 28/03/2020 00:42:39:

Smart work Celso.

Emgee

Thanks mate,

Celso Ari

[celso ari schlichtingParticipant @celsoarischlichting85092]

Posted by Pete Rimmer on 28/03/2020 08:51:41:

Teriffic work Celso, as usual. However I'd have to question the concentricity of the collet taper to the spindle OD given that you had it held in the 3-jaw. I think you might find that you have to clock the OD in a 4-jaw and cut that taper again. Even tiny amounts of concentric error show up when you're sharpening cutters etc.

excellent tip, I will check the taper and if necessary I will correct. 
Thank you for the advice

Celso Ari

[celso ari schlichtingParticipant @celsoarischlichting85092]

Posted by thaiguzzi on 28/03/2020 09:38:26:

Like button pressed…

thanks, the channel on YT needs a lot of likes

Celso Ari

[Author]

Posts