Jason, I followed that link to the Warco saw – Blimey what a price! The fact that the Chester site invites you to enquire for their prices rather leads me to believe a small mortgage will be required, too. You (Choochoo-Baloo) could get an awful lot of laser- or water-cut plates for a hundredth of that outlay. Unless you are going into production, of course.

John

I recently bought a secondhand Myford ML8 woodwork bandsaw attachment with the intention of using it for metalwork. They occasionally come up on ebay for about £80 – £100. I have secondhand ML8 lathe (there are plenty of those on ebay) and have shortened the tubular bed to make the bandsaw into a dedicated machine. Having said that, the unused side of the headstock might be fitted with a faceplate and table, and used as a disc sander.

The Myford bandsaw is very solidly made and I hope it will be good for metalwork. It's quite small by woodwork standards but big enough for my metalwork. The plan is to use the pulleys in the headstock to slow down the blade speed and if necessary a variable speed drive on the motor.

Andrew

I have an old Startrite with 12" diameter wheels. Designed for wood I was cutting 1/2 inch aluminium with a skip tooth blade. The blades didn't last long.

I have bought a new, 47 rpm gear motor with 80Nm of torque from Geared Motors UK which will take it down to 2.5 ft/s 150 ft/min which sounds just about perfect to me.

It seems I can buy most any blade in any length, I am going to enjoy this!

80Nm translates to a 118 lbf push on the blade. Wonder if it will slip

The Jet saws seem to be evolved from the old Delta and Walker-Turner 14" saws. I have a 14" Delta for wood & metal. It has a built-in gear reduction for metal cutting. I find it quite satisfactory for cutting metal, including steel. There are a lot of 14" Delta clones built in Asia. I would be very surprised if they were not available in Europe.

CCB – I have a Femi horizontal saw and you can purchase or make – very easily – a table to use it in the vertical position, it is not in the same league as a Startrite or similar but it works well enough for the home workshop. Yes they are by comparison to the Eastern offerings but I have never regretted my purchase, the table accessory is expensive and very easy to make,

Would i buy the saw agin — defiantly but not the table I would make one. See the link to one supplier and if you scroll down you can see the table accessory .

**LINK**

Should yo go down this route and wanted details of the table just PM me.

John

I've had the 'generic' 6×4 saws in the past and would agree they are not the greatest, bought one of these from Axminster a couple of years ago and it has not let me down, cut accurately straight out of the box, can be used vertically (although you do need to make a decent table for that mode of use)

Many smaller hobby bandsaws use commutator motors – speed dependant on voltage. Lower power at lower voltage, of course, but there are plenty of voltage controllers around these days.

I’ve seen lots of threads on forums over the years about reducing the speed of a wood cutting bandsaw to enable it to cut metal. The only successful conversion I saw however was made by copying the multi pulley system used in the JET bandsaws I linked to earlier.

If you look at the diagram on page 8 here:

**LINK**

You can see the drive setup is considerably different to a standard wood cutting bandsaw.

The drive speeds available on the JET are 3300 SFPM for wood down to 39 to 278 SFPM for steel etc.