5c length

[mick70Participant @mick70]

[mick70Participant @mick70]

got what i assume is a collet holder with my clarkson.

id matches dia of 5c collet on arc site.

but doesn't give length of holder is 3" would that be right for 5c collet?

cheers

[Ketan SwaliParticipant @ketanswali79440]

See below: Measurements in mm. Also in Album in case you cannot read the measurements from the picture below.

Ketan at ARC.

[mick70Participant @mick70]

looks like it should fit, just ordered one to try if it does will get more.

will need to make drawbar for it first.

[BazyleParticipant @bazyle]

no, the clarkson standard universal head does not have the taper part for a 5c. They are just custom sleeves. Since milling cutters only come in a smzall number of shank sizes. If your head does have a taper it has been specially made so you may be in luck.

If you follow the link i gave onyour first clarkson thread it has lots of pictures of the correct parts and i think some dimensions

[mick70Participant @mick70]

Bazyle link was very useful.

this is sleeve someone made for it at some point.

[mick70Participant @mick70]

Finally bit of luck after bad week the 5c collet fits perfectly.

[mick70Participant @mick70]

Finally bit of luck after bad week the 5c collet fits perfectly.

[Author]

Posts