cross slide

This topic has 7 replies, 4 voices, and was last updated 25 April 2011 at 23:32 by ady.

Viewing 8 posts - 1 through 8 (of 8 total)

Author

Posts
24 April 2011 at 07:13 #67433
cva-glen
Participant
@cva-glen
Good morning ,This is my first post, so hello to you all.I have a cva lathe with a taper turning attachment fitted, i need to remove the crossslide-RUST,any idea what the procedure is?.The taper attachment needs a refurb anyway, just don`t want to take apart in wrong order.Thanks for any help given-glen
Advert

24 April 2011 at 07:13 #11771
cva-glen
Participant
@cva-glen
taper turning
24 April 2011 at 08:51 #67434
cva-glen
Participant
@cva-glen
Hi Graham,thanks for the reply.It`s a mk1a series3 toolroom lathe-aug 56.based on a monarch10ee but without the electric problems,although if i could get my hands on a 10ee,drool!!!.I have been on tonys site-mechanical porn!.i will take it apart,just thought i might get some tips before i start.I`ve had the lathe for a while,just never got round to fetlin her.what model holbrook? glen
24 April 2011 at 13:35 #67445
Steve Garnett
Participant
@stevegarnett62550
Posted by Graham Meek on 24/04/2011 13:26:06:

The Holbrook that I worked was a very nice machine, but I must say my heart lies with the Hardinge HLV, but no doubt not all will agree with me.

I do – thread-cutting heaven! But that’s going to have to wait for a while…

I was going to comment on what I have to do to achieve the same thing on the Kerry, but as John has more direct experience, I’ll leave it to him.

Edited By Steve Garnett on 24/04/2011 13:48:02
24 April 2011 at 13:38 #67446
John Stevenson 1
Participant
@johnstevenson1
I have one and it is possible to just remove the cross slide without touching the TT attachment,

Give me a few hours to go look and post back.

John S.
24 April 2011 at 16:53 #67459
cva-glen
Participant
@cva-glen
Thanks John,glad you have been in touch as i know you have a cva.I hope you don`t mind me picking your brains in the future.

Gray, I will have to find out about the holbrook, sounds like a nice peice of kit.Has anybody got a No1 cva-the round one before they squared it off.It would be nice to see some photos if you don`t mind-never seen one

glen
25 April 2011 at 16:04 #67507
cva-glen
Participant
@cva-glen
Update.On closer inspection of the tta i found three of the four bearings have shattered!,so i am going to strip the whole unit down as there are bits everywhere.should be fun

glen
25 April 2011 at 23:32 #67520
ady
Participant
@ady
Just in case you haven’t done it before I found a bucket/tray of good malt vinegar very effective in removing rust from the old pultra cross slide bits I had.

There are piccies in my profile.

Dunk the dismantled gear for up to a week in the vinegar and the rust gets eaten away to a kind of gunk you can clean off with a soft wire pad pan scourer and rubber gloves, almost no elbow grease is required.

Wipe it dry and oil it up.
Author

Posts