Hi from Wales

[Alan GoslingParticipant @alangosling27395]

I am retired and a ex merchant navy chief engineer. Just received an old Emco Unimat 3 lathe and milling attachement from my father in law. Looking to see what i can do with it, but the vertical mill drive pulley is broken.

Just about to put a forum message up about spares

[Alan GoslingParticipant @alangosling27395]

[Henry BrownParticipant @henrybrown95529]

Welcome Alan, lots of ideas to get you going when you have the machine fixed! Good luck with the pulley…

[George JervisParticipant @georgejervis86082]

Hi Alan,

Welcome to the forum from another member in Wales (sy16 Powys area) good luck fixing your lathe

George

[BazyleParticipant @bazyle]

Now you have a lathe find any nearly right pulley and make the adaptor to fit?

[Brian HParticipant @brianh50089]

Hello Alan and welcome.

My first thought for a pulley was Picador but my PC says that their site is not secure, so I tried Chronos and found this;

**LINK**

Best of luck with the repair.

Brian

[Harry WilkesParticipant @harrywilkes58467]

Welcome to forum

H

[Author]

Posts