New Member in Cornwall

[Brian Stretton 1Participant @brianstretton1]

Hi to All,

I have a small engineering workshop which includes a 5" Raglan Little John, small universal mill, drill press etc. I have made a few Stuart stationary engines over the years and always have a project or two on the go.

Unfortunately my father who was a very keen model engineer has been unwell for some time and is now in a nursing home. I am now slowly tiding up and clearing out his engineering bits and pieces, a lot of the engineering stuff can go on eBay, however not so sure about the 3.5” Stanier Black Five and a 7 ¼” Dart Valley 0-6-0 loco’s, I am hoping for some advice on where and how to sell them if anyone can give some pointers?

[Brian Stretton 1Participant @brianstretton1]

[Neil WyattModerator @neilwyatt]

Hello Brian, welcome to the forum. I hope you decide to stay after sorting this out!

You might find this article by Roger Backhouse useful: Disposing of a Workshop.

Neil

[Brian Stretton 1Participant @brianstretton1]

Hello Neil,

Thanks for the link to 'Disposing of a Workshop' there are some interesting points in the post that I never considered.

Brian.

[Author]

Posts