The world of model and hobby engineering
Forums
Help
Register
Log in
Home › Forums › General Questions › new progress no 1 pillar drill
CliveHi, I have just purchased a progress no 1 pillar drill but there is only a single pulley on the motor, I'm hoping that some one on here could let me know what sie pulleys it should have so I can get it working correctly, Many thanks
How many sheaves on the spindle end pulley ?
If memory serves it’s virtually the same as the one on the quill only upside down? I can check tomorrow though if needed.
I found this if it is of help
regards
the front pulley has 5 slots for the pulley
Looking at the drill again, the motor pulley is a bit smaller than the quill pulley.
I’m not sure it would be that critical except whatever set of pulleys you get must obviously fit within the casing and cover!
Home › Forums › General Questions › Topics
Started by: Graeme Seed in: Workshop Tools and Tooling
Graeme Seed
Started by: bricky in: Help and Assistance! (Offered or Wanted)
Started by: John MC in: CAD – Technical drawing & design
Paul Lousick
Started by: Michael Gilligan in: Manual machine tools
southernchap
Started by: IanT in: Workshop Tools and Tooling
IanT
Started by: Chris Kirby 1 in: Help and Assistance! (Offered or Wanted)
Norman Billingham
Started by: David George 1 in: Workshop Tools and Tooling
bernard towers
Started by: Geoff Dunsby in: General Questions
Started by: Andrew Tinsley in: General Questions
Julie Ann
Started by: Geoff Byman in: Beginners questions
JasonB
Started by: Werner Schleidt in: Exhibitions, Shows and Club Events
Werner Schleidt
Started by: blowlamp in: CAD – Technical drawing & design
Bazyle
Started by: Speedy Builder5 in: Workshop Tools and Tooling
old mart
Started by: Geoff Dunsby in: Workshop Tools and Tooling
Geoff Dunsby
Started by: Peter Simpson 3 in: Beginners questions
duncan webster 1
Andrew Tinsley
Started by: AJBAJB in: Locomotives
AJBAJB
Started by: Dalboy in: Materials
Phil P
Started by: JasonB in: The Tea Room
Speedy Builder5
Started by: Graham Meek in: Manual machine tools
Pete
Started by: engineeredbyhansson in: Manual machine tools
engineeredbyhansson
Started by: Geoff Dunsby in: CAD – Technical drawing & design
Started by: BOB BLACKSHAW 1 in: CAD – Technical drawing & design
renardiere7
Graham Meek
Started by: BOB BLACKSHAW 1 in: The Tea Room
Martin Connelly
View full reply list.