The world of model and hobby engineering
Forums
Help
Register
Log in
Home › Forums › Workshop Tools and Tooling › Moore and Wright 2-12″ inside mic handle thread
I’m looking for information…
I’ve managed to loose the handle from my Moore and Wright 2-12″ inside mic,(I say I lost, but it came back from a borrowing!).
Could some tell me what the thread is? Dia and tpi would do.
Thank youJim
Imperial mics are usually 40 tpi. One rotation of the thimble gives a .025" linear movement, hence the barrel marked in .025" incremens.
George.
Jim, I'm assuming that you mean the thread on the rod that is used to hold the mic in a bore whilst measuring it. If so, it is 6BA.
Brian
Err, OP said the handle, not the micrometer.
The thread on my M&W internal mic handle measures 0.127" OD, which points to 5BA, nominally 0.126" OD.
Andrew
Excellent!
I was loathed to start trying taps in the hole.
Thank you
Jim
Just made a handle for my M&W 2-12 internal mic. 5BA.
John
Sorry Jim, I made it 6BA by trying nuts on the thread! I'll give it a proper measure tomorroe and get back to you.
I’ve just checked and luckily I’ve got a good 5BA and 6BA. Thanks again
I missed the word die out…..
Home › Forums › Workshop Tools and Tooling › Topics
Started by: IanT in: Workshop Tools and Tooling
Geoff Dunsby
Started by: Geoff Dunsby in: General Questions
David George 1
Started by: John MC in: CAD – Technical drawing & design
JasonB
Started by: David George 1 in: Workshop Tools and Tooling
Dave Halford
Started by: Graeme Seed in: Workshop Tools and Tooling
Alan Jackson
Started by: Chris Kirby 1 in: Help and Assistance! (Offered or Wanted)
Chris Kirby 1
Started by: Michael Gilligan in: Manual machine tools
Andrew Tinsley
Started by: Graham Meek in: Manual machine tools
Colin Creed
Started by: bricky in: Help and Assistance! (Offered or Wanted)
Graeme Seed
Started by: Andrew Tinsley in: General Questions
Julie Ann
Started by: Geoff Byman in: Beginners questions
Started by: Werner Schleidt in: Exhibitions, Shows and Club Events
Werner Schleidt
Started by: blowlamp in: CAD – Technical drawing & design
Bazyle
Started by: Speedy Builder5 in: Workshop Tools and Tooling
old mart
Started by: Geoff Dunsby in: Workshop Tools and Tooling
Started by: Peter Simpson 3 in: Beginners questions
duncan webster 1
Started by: AJBAJB in: Locomotives
AJBAJB
Started by: Dalboy in: Materials
Phil P
Started by: JasonB in: The Tea Room
Speedy Builder5
Started by: engineeredbyhansson in: Manual machine tools
engineeredbyhansson
Started by: Geoff Dunsby in: CAD – Technical drawing & design
Started by: BOB BLACKSHAW 1 in: CAD – Technical drawing & design
renardiere7
Started by: BOB BLACKSHAW 1 in: The Tea Room
Martin Connelly
View full reply list.