Emma Victoria – Valve fork fixing

[Henry WoodParticipant @henrywood50588]

To all those who are building Emma-Victoria, with regards to the fixing of the fork end to the cylinder valve spindle. On the cylinder drawings I have shown the spindle with a 5/32" x 40 thread, however on the fork end detail I have shown a 5/32" reamed hole and pinning. My original intention was to quote both methods but I didn't make this note on the drawings and in the write up. I have used both methods in the past and both are O.K. I hope this will not have caused any problems for those who are building.

Regards

Henry

Edited By JasonB on 28/05/2014 07:38:29

[JasonBModerator @jasonb]

[Author]

Posts