clarkson tooling and cutter grinder mk 1

[mick70Participant @mick70]

have just aquired a mk1 clarkson for scrap value as cabling had all been cut off before going into storage 10 yrs ago.

all worked ok before though.

still all in good nick but didn't meet safety rule's coy were demanding.

am struggling to find downloadable manual, only one's i can find start at £35.

as anyone got one they e=mail me pls?

[mick70Participant @mick70]

[Involute CurveParticipant @involutecurve]

To be honest I wouldn't bother, I have a printed manual I bought from lathes.co.uk
Its the official March Engineering Mk1 and Mk2 cutter grinder Manual, its more a catalogue of accessories than a user guide, there is some user stuff in it but not very much.

[BazParticipant @baz89810]

You would most probably be better off buying a copy of the Quorn book, that contains quite a bit of info on actual set ups. As Involute Curve says, all the Clarkson stuff is basically a catalogue.

[BazyleParticipant @bazyle]

The manual doesn't contain a parts list or diagram if that's what you were after.

Loads of stuff on this site.

If you don't have an universal head then the Stent design covers it if you can find the ME articles. Probably also got instructions on using it too.

[mick70Participant @mick70]

cheers for replies.

whats issue is stent article in?

club as copies going back years.

[RobboParticipant @robbo]

If your club gets Model Engineers Workshop there was a series of 6 articles on the Clarkson in issues nos 148 thru 153.

[mick70Participant @mick70]

that bedroom workshop is a great site.

[Author]

Posts