Digital readouts

This topic has 9 replies, 8 voices, and was last updated 23 March 2022 at 12:18 by HOWARDT.

Viewing 10 posts - 1 through 10 (of 10 total)

Author

Posts
22 March 2022 at 20:51 #591165
Calum
Participant
@calumgalleitch87969
I don't want or need to go full DRO on my lathe, but I do want to be able to drill holes with a cross-drilling fixture in the cross-slide into a workpiece held in the lathe. These things seem ideal for the job and should be more than accurate enough:

Warco, whose picture above I have, ahem, borrowed, are sold out of the 1000mm length ones and I can't find one anywhere else at close to the price. eBay doesn't seem to have such a thing under £130, and Aliexpress has something a good bit cheaper but with extraordinary shipping costs. Can anyone suggest cheaper options?

(I know I probably don't need a 1000mm slide on a ~1m bed, but it will look tidier and give me more options for mounting, and, well, easier to make a long thing shorter than a short thing long)
Advert

22 March 2022 at 20:51 #28633
Calum
Participant
@calumgalleitch87969
22 March 2022 at 20:59 #591166
bernard towers
Participant
@bernardtowers37738
How about MDRO
22 March 2022 at 21:00 #591167
DC31k
Participant
@dc31k
https://www.arceurotrade.co.uk/Catalogue/Measurement/Digital-Readouts-with-Dedicated-Remote-Display/Digital-Readout-Bars-with-Dedicated-Remote-Display
22 March 2022 at 21:03 #591168
Paul Lousick
Participant
@paullousick59116
Lots of previous posts about readouts.

They work OK BUT do not last. I had to replace the ones on my mill 3 times after they failed. Now have a decent set of scales made by Easson.
22 March 2022 at 23:51 #591192
Huub
Participant
@huub
I use these scales (from igaging) on my mill for several years now and they are OK. However, these scales are not swarf or water proof. So I made a "protective" cover to protect against swarf (I don't use coolant on the mill)
23 March 2022 at 07:23 #591210
Gary Wooding
Participant
@garywooding25363
Posted by Huub on 22/03/2022 23:51:35:

I use these scales (from igaging) on my mill for several years now and they are OK. However, these scales are not swarf or water proof. So I made a "protective" cover to protect against swarf (I don't use coolant on the mill)

?
23 March 2022 at 10:33 #591231
Stuart Smith 5
Participant
@stuartsmith5
Arcurotrade sell these. I have 3 of them on my Warco mill. (As per the link from DC31k earlier).

I found the display a bit small so built an adapter to use the TouchDRO app on a cheap Android tablet for the display.

Stuart
23 March 2022 at 11:07 #591237
DC31k
Participant
@dc31k
Posted by Stuart Smith 5 on 23/03/2022 10:33:37:

I found the display a bit small…

Any thoughts whether something like this could serve as an alternative to your solution?
23 March 2022 at 12:18 #591248
HOWARDT
Participant
@howardt
Need good protection to minimise swarf ingress, depending on lathe it may be very close to cutting point. I had one on my mill, lasted about twelve months then readout was all over the place even though well covered.
Author

Posts