Table in the Mk1 Clarkson cutter grinder manual.

[Andrew TinsleyParticipant @andrewtinsley63637]

I have a scruffy copy of the above, which is still very readable, except for the table of Reliefs and Clearances on page 23. Large parts of it are indecipherable. This table is really quite indispensable if you are sharpening spiral fluted cutters!

I know I can buy a photostat of the manual off Ebay, for around £18, which is rather a lot, when I only need one page. By any chance, would anyone have a readable copy of page 23 that they could copy for me?

Thanks,

Andrew.

[noel shelleyParticipant @noelshelley55608]

Hey, Andrew, I will dig out what I have see if I have what you need.  Noel.

[Andrew TinsleyParticipant @andrewtinsley63637]

Hello Noel,

Much appreciated! its just page 23 that is unreadable. I can really do without paying £18 or so just for one table. I am afraid I am one of the hobbies cheapskates!

Andrew.

[Michael GilliganParticipant @michaelgilligan61133]

I presume this is the Mk 1

… as it doesn’t state otherwise

http://vintagemachinery.org/pubs/12494/27936.pdf

MichaelG.

[noel shelleyParticipant @noelshelley55608]

I have had a quick look for the file of my docs on the Clarkson but in the mean time Michael has come up with it. I hope P23 is what you need as I think my copy came from the internet.  Noel.

[Andrew TinsleyParticipant @andrewtinsley63637]

Hello Noel and Michael,

Many thanks to you both. I now have a readable copy of page 23! Interestingly enough, this is the second “thank you”, that I have written. The first one was sent by pressing the submit button and my reply then appeared again, so I assumed that it was posted on the topic. I just checked again and found it wasn’t there!

Andrew.

[Author]

Posts