CNC Utilities

[SillyOldDufferModerator @sillyoldduffer]

Posted by richardandtracy on 18/05/2017 16:36:15:

The bar diameter is set by the start point, and it assumes the start point is at the right hand corner of the bar, as shown on page 1 of the pdf help file. The units have to be consistent throughout, and all entered radii/diameters all have to be radii or diameters.

The ER collets all have a minimum bar diameter the 'collet number + 1or2mm', eg ER32 min dia is 33mm

Hope that helps,

Regards,

Richard

It does indeed Richard. I suspected whilst typing that the problem might be me. Although I eyeballed the pdf I didn't read it properly.

The good news is that the the program works OK under Wine, which might encourage Linux fans to use it. Also that the program is documented, a very good thing if the user takes the time to understand it.

Dave

[Author]

Posts