Slide thread pitches, handwheel graduations?

Slide thread pitches, handwheel graduations?

Home › Forums › Beginners questions › Slide thread pitches, handwheel graduations?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #320817
    bugbear6502
    Participant
      @bugbear6502

      I was looking at the topslide on my Simat. Having watched (too many!) videos on youtube where lathe work is done by using the engravings on the hand wheel, I noted that (unlike some cheap/early/small lathes) the plastic wheels on the Simat are engraved (actually, they''re injection moulded).

      At first glance, they're marked 0/3, 1/3, 2/3 on the conical section, with normal "ticks" closer in. Counting the ticks, there are 7 (SEVEN!!!) in each third, for a total of 21 divisions.

      "Slightly" confused I measured the thread, which turns out to be 24 TPI.

      Each tick is thus 1/21 of 1/24 of an inch, which is 1/504. 2 thou within 1% tolerance. ideaOh, very clever.

      But the whole 7ths/3rds thing will make my brain explode for any movement other than small depth-of-cut increments.

      I suppose I'd better see what weirdness awaits on the lead screw + wheel

      BugBear

      #8904
      bugbear6502
      Participant
        @bugbear6502
        #320909
        bugbear6502
        Participant
          @bugbear6502

          Lead screw measured with a thread gauge at 14 TPI; the handwheel has 5 divisions labelled 0, 20, 40, 60, 80, and each division has 5 ticks.

          Each tick is 1/14/25 = 1/350, or 2.857 thou.surprise

          I understood the cross slide better!

          BugBear

        Viewing 3 posts - 1 through 3 (of 3 total)
        • Please log in to reply to this topic. Registering is free and easy using the links on the menu at the top of this page.

        Latest Replies

        Home › Forums › Beginners questions › Topics

        Viewing 25 topics - 1 through 25 (of 25 total)
        Viewing 25 topics - 1 through 25 (of 25 total)

        View full reply list.