That is such a shame that nobody has take you up on the offer.

I would have asked for it but I am a total beginner and feel that I would not do it justice as it is I have just started the Rob Roy as a first project and seeing how far I have got since starting it is going to be a long slow build but then I am enjoying every minute of it.

I hope it finds a good home with someone who will see it's full potential.

Bill, as I said in the other thread it would not be too hard to either fabricate or cut from solid a pair of cylinders and the remaining parts. I'm sure I saw one like this a week or two ago but can't recall where.

I could probaby be talked into taking it on but may not be top of the list to get done.

I have posted some bits in the "What Did you do Today" on the forth page was the first dry fit of frames to buffer beams>

So where did the 12mm and 14mm cylinder mounting flange sizes come from?

Thank you for the kind offer Bill as I stated I will not do it justice so will pass I have sent a reply by PM

Bill

I have sent you a PM

Phil

You said to me in your last message you had someone else who wanted it so it's obviously not a total reject.

Having seen it in primer OI would say it is actually a home built fabrication, you can easily see that the flywheel spokes have been milled out and under the paint it looked like the leg of the frame was soldered to the trunk guide