New member with a Mellor lathe.

[Spencer OrdParticipant @spencerord84987]

Hi and good evening everyone. My name is Spencer and I have just joined the forum. I am looking for a little help if possible. I have a 3.5×20 Mellor lathe in very good condition. But unfortunately I am missing a little cog that operates the power cross slide. Also looks like the thread end has been sheared off. Has anyone got a Mellor lathe. If so would it be possible to take a photo of the little cog in place.

[Spencer OrdParticipant @spencerord84987]

[peak4Participant @peak4]

Hello and welcome, Does the last photo on This Page assist any?

Bill

[Spencer OrdParticipant @spencerord84987]

Hi. Thanks for your reply. I did see these pictures on lathes uk. The black cover that’s at the back is where the cog is located. I will see if I can post a picture of mine.

Edited By Spencer Ord on 14/11/2017 21:39:23

[Spencer OrdParticipant @spencerord84987]

I have managed to upload a couple of pictures to my album named Mellor.

[Author]

Posts