Need advise please

This topic has 8 replies, 6 voices, and was last updated 8 January 2018 at 22:09 by wayne larsen.

Viewing 9 posts - 1 through 9 (of 9 total)

Author

Posts
8 January 2018 at 19:20 #9039
wayne larsen
Participant
@waynelarsen80726
Cl500 gearing
Advert

8 January 2018 at 19:20 #335961
wayne larsen
Participant
@waynelarsen80726
Hello all I’m a Newby. Just bought my first lathe, could someone give me some advise on setting up the gearing as the manual is not clear. I’m trying to set it at 400rpm can someone varify what belt should be on what pully,a pic would be great. Thanks
8 January 2018 at 19:53 #335963
JohnF
Participant
@johnf59703
Want, more info needed on your lathe, make model and a photo may be useful
8 January 2018 at 20:00 #335965
SillyOldDuffer
Moderator
@sillyoldduffer
Says it's a CL500 in the post's sub-title. Sorry I don't know that one but someone will.

Welcome Wayne,
8 January 2018 at 20:07 #335968
Neil Wyatt
Moderator
@neilwyatt
Welcome to the forum Wayne

http://www.clarkeservice.co.uk/product_manuals/metalworking_lathes.shtml

It looks like you need a belt on the largest pulley of the lower cluster to the smallest of the middle cluster, then a belt from the next smallest pulley on the middle cluster to the smallest pulley on the top cluster.

There are some CL500 owners around here, hopefully one will pop in in a bit.

Neil
8 January 2018 at 20:17 #335970
mick70
Participant
@mick70
make sure you have right manual as when i bought mine manual was wrong.

look at step pulley on motor behind the big pulley is a small one.

unless you know its there you'll never realise.
8 January 2018 at 20:20 #335972
mick70
Participant
@mick70
just looked at link and it as new manual on it.

another thing worth knowing is thread chart in manual is wrong go by one on rear guard inside.
8 January 2018 at 20:56 #335980
richardandtracy
Participant
@richardandtracy
I have a CL430 & the Warco version of the CL500. (Just establishing a credential)

On the motor spindle in the belt box, there are 4 grooves on the pulley, put the belt on the smallest one nearest the motor, it's hidden behind the biggest pulley groove and almost rubs on the back of the belt box. Then the other end of that belt goes parallel to the box onto the biggest groove in the middle pulley. Then on the middle pulley put a second belt on the next biggest groove. The lathe spindle end of that belt, goes onto the smallest goove of the lathe spindle pulley.

If it's all too tight to fit the lathe belt, there is a motor position adjuster between the motor and the lathe bed.

Hope that helps,

Richard.
8 January 2018 at 22:09 #335988
wayne larsen
Participant
@waynelarsen80726
Thanks for all the replies guys, I would not have found the small pulley hidden at the rear of the motor pulley. All up and running now. Just need to build a new bench for it now as it’s moving to much on this one. 🖒
Author

Posts