5/16″ pipe fittings – supplier or drawing required

5/16″ pipe fittings – supplier or drawing required

Home › Forums › Beginners questions › 5/16″ pipe fittings – supplier or drawing required

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #7305
    Phil Catchesides
    Participant
      @philcatchesides15448
      #163779
      Phil Catchesides
      Participant
        @philcatchesides15448

        Pansy specifies a 5/16 pipe from the superheater hot header to the cylinder with a single pipe union to connect but I can't find a supplier or a drawing of the union – can anybody help?

        Thanks, Phil

        #163781
        JasonB
        Moderator
          @jasonb

          Assuming you are using nuts and nipples/ferrules then all you need is a bit of hex brass, turn down and thread each end to suit the nut leaving a small length of hex in the middle. Drill say 1/4" through and use a large centre drill to form seats for the nipples.

           

          This sort of thing but a bit larger

          Edited By JasonB on 17/09/2014 16:03:54

        Viewing 3 posts - 1 through 3 (of 3 total)
        • Please log in to reply to this topic. Registering is free and easy using the links on the menu at the top of this page.

        Latest Replies

        Home › Forums › Beginners questions › Topics

        Viewing 25 topics - 1 through 25 (of 25 total)
        Viewing 25 topics - 1 through 25 (of 25 total)

        View full reply list.