How does a 14.25 wide nut fit in a 13.5 wide slot Dave ?

Nigel B

Someone who cannot be named for legal reasons screwed up the drawing, dimensioned it, and then failed to check it still made sense. You may think it was me who blundered, I could not possibly comment.

The slot is 13.8mm wide, and the T-nut 13.5

Apologies all round and many thanks to Nigel in Quality Control!

Dave

Here you go-

So you need 'T' Nuts to the Dims of item 9524 above. Only come with 12mm threaded stud holes.

Regards

My VMC has the same 14mm Nom slot width.

If you are thinking of a new clamp set then a little food for thought:

I bought the standard 14mm x M12 clamp set available for this T slot size.

IMO after using it for a while I found it overkill and rather clumsy ( big clamps etc ) for the table size, so I opted to buy the next size down M10 clamp kit and made 6 x new 14mm x M10 T-Nuts. I find this more suited for my needs and more a balanced/matched set for this size of table and machine size.

I have kept the first clamp set per chance it was needed and it has been just a couple of times, but only because I needed some addition studs and clamps for a double setup i had on the table.

Edited By MalcB on 15/02/2017 14:15:26