There were two minor errors in the cutting speed table in David Clark's Teach In article in issue 216 of Model Engineer's Workshop, caused by errrors in the spreadsheet.
As this is such a useful chart, a pdf copy is reproduced here, which can be printed out and stuck up in the workshop.
www.model-engineer.co.uk/…/documents/cutting speed chart.pdf
Article continues below…
Enjoy more Model Engineer Magazine reading.
Click here to subscribe & save.
Hi,
I'm the editor of Model Engineer & Workshop magazine and before that the editor of MEW from 2014, also one of the website admins.
I'm a model engineer, and in the past I have written for ME and MEW, but I won't claim any great stock of expertise, just plenty of enthusiasm. Before becoming editor, I used to post on this forum as Stub Mandrel (and may occasionally still do so).
If you would like to find out more about me, my personal website is <a href="http://www.stubmandrel.co.uk/">www.stubmandrel.co.uk/</a> and I have an author page on Amazon at <a href="https://www.amazon.co.uk/Neil-M-Wyatt/e/B01FK687I0/ref=ntt_dp_epwbk_0">amazon.co.uk/Neil-M-Wyatt/</a>
Feel free to send me a 'pm' (message member) but these are a bit slow and clumsy, so if you would like to get in touch with me by email use <a href="mailto:
[email protected]">
[email protected]</a>
I'm always glad to hear your views on the magazine, and particularly keen to encourage new contributors to 'have a go', so let me know if you have any ideas for articles.
I hope to hear from you soon.
Neil
