|Keith Halton||23/11/2020 21:02:49|
|6 forum posts|
I need to move a Super 7 and am trying to disconnect the lathe from the table it is mounted on. I've removed the four coach screws that hold the bed down but the lathe is still attached to the table by the on/off switch. See two photos below. So far, I haven't worked out the best way to separate lathe and table. It looks like there is a short (1" or so) length of conduit firmly holding the lathe and table together. Any suggestions on how to get them apart?
|Martin Kyte||23/11/2020 22:20:14|
2155 forum posts
Unscrew the brass nipple where the wires feed through into the Dewhurst switch.
1779 forum posts
Yes . as above. Isolate the supply. Mark & disconnect the wires. Remove the brass bush & it should be free.
Edited By Steviegtr on 23/11/2020 23:50:16
Please login to post a reply.
Want the latest issue of Model Engineer or Model Engineers' Workshop? Use our magazine locator links to find your nearest stockist!
You can contact us by phone, mail or email about the magazines including becoming a contributor, submitting reader's letters or making queries about articles. You can also get in touch about this website, advertising or other general issues.
Click THIS LINK for full contact details.
For subscription issues please see THIS LINK.