low profile vise

Edited By celso ari schlichting on 11/10/2019 20:29:07

Nice work on the vise, must find time to make something similar for my small milling machine.

Thor

Good work again from Celso Ari. I'm always quietly impressed by his work.

Loads of good stuff is posted on the forum and then only admired silently. I hope this apparent lack of interest doesn't put anyone off. It's the audience, the British are famously undemonstrative!

Keep it coming.

Thanks,

Dave

NEAT!

You have used two pieces, with a moving jaw, where my "Infinite Vice" is in three parts.

Now you have made me another job on the Round Tuit; to mill a rebate inn the fixed and moving jaws, like yours, to reduce the need for parallels under the workpiece.

Did you dowel or key the jaws to the Tee slots?. Neater than the side cheeks on the jaws of mine for location! 

Howard

Edited By Howard Lewis on 12/10/2019 12:52:46

Howard, I couldn't understand the question. can you do it again? My english is not good, we speak portuguese here in my country (translation problems he he)

greetings from Brazil

Celso Ari

Hi!

Your English is much better than my inability to speak Portugese!

How are jaws aligned to the table?

Are there keys to locate the jaw to the Tee slot?

Or do you have dowels under the jaws to locate inn then Tee slots?

Regards

Howard

Most impressive Celso, will have to make one when I get back in to the shed.