|tom hardy||18/09/2019 12:24:54|
|11 forum posts|
where can i buy steel reinforced lifter hose for a 1 1/2 traction engine
|Brian Sweeting||19/09/2019 14:57:53|
|403 forum posts|
What size tube are you looking for and material type?
There is a good range of 'plastic' reinforced tubing available.
17283 forum posts
Quite a few makers get a small rubber hose and then wind thing galvanized wire around it. You can leave as that or add a layer of self amalgamating tape. MJ Engineering do some suitable black rubber hose for just that job
Heritage steam sell scale water lifter hose but only for the large scale engines
|Clive Brown 1||19/09/2019 15:16:27|
|346 forum posts|
For the 1 1/2" Allchin, W Hughes described wrapping tinned copper wire around 1/4" rubber tube. He suggested grey tube, which is not common, and fuse wire, 10 or 15 amp, I forget which, but it's 0.015" dia or 28 swg.
His method was to wrap 3 lengths of wire side by side, then remove 2, to give the spacing.
|380 forum posts|
Nip over to your nearest hydraulics & hose supplier or agricultural outlet. Depending where you are you could try these people. They will always help the small user. Hose supplier regards
Sorry just noticed you are in WA from your earlier posts. The info should be of help to yourself and others though I hope
Edited By Oldiron on 19/09/2019 15:22:18
Edited By Oldiron on 19/09/2019 15:25:27
|Trevor Drabble||19/09/2019 15:25:07|
205 forum posts
As per Jason's suggestion , Blackgates also sell a selection of suitable hose in different diameters.
|tom hardy||21/09/2019 00:52:22|
|11 forum posts|
thank you people for the info well done
|Neil Wyatt||21/09/2019 21:37:41|
17334 forum posts
I came across a suggestion of winding a loose spring with hard stainless steel wire, then inserting it into a tube of heat-shrink tubing. I imagine it isn't very flexible, but not sure how much you need it to bend.
|Nick Clarke 3||22/09/2019 09:46:32|
559 forum posts
Does it need to be steel reinforced or to have the appearance of steel reinforced?
In an article about making vacuum brake pipes W.A (Bill) Carter described how to wrap wire around a pipe and run an electric current through it to burn the appearance of the corrugations into the pipe.
If you need it I will dig out the reference to the issue.
Please login to post a reply.
Want the latest issue of Model Engineer or Model Engineers' Workshop? Use our magazine locator links to find your nearest stockist!
You can contact us by phone, mail or email about the magazines including becoming a contributor, submitting reader's letters or making queries about articles. You can also get in touch about this website, advertising or other general issues.
Click THIS LINK for full contact details.
For subscription issues please see THIS LINK.