Due to my zealous output, I have been 'advised' to split the original thread.
|Sam Stones||23/04/2019 00:57:03|
647 forum posts
As a convenience, here is roughly where Thread Part A ended
To conclude, perhaps I should have carried the exercise to include deepening the meshing, i.e. crossing over the two PCD’s. However, I’m inclined to think that the results would be fairly obvious in that the teeth/leaves/pins would soon clash.
Unlike the previous exercise where contact of wheel teeth and pinion leaf flanks produced slight changes of contact traces (especially the ‘On centreline and 0.1mm offset), the round pins of the lantern produced smooth curves. Similarly, as here …
… the cross-overs of the pressure angles are less severe.
Finally, and despite my own luck, only slight changes in depth from the theoretical (i.e. less than 1.0mm) suggest that depthing, at these sizes in particular, needs to proceed with extra care. No doubt for those with depthing experience, you will recognise how the meshing behaves. Too deep and there will be a gnashing of teeth? Too shallow, more gnashing?
Links to both albums are here …
Meshing with Cycloids
Meshing with Lantern pinions
Thanks for everyone who helped.
Apologies if this mesh came unstuck.
|Michael Gilligan||23/04/2019 07:03:10|
14014 forum posts
Blessed are the Lantern Pinions ... for they follow the true path
|Sam Stones||23/04/2019 20:05:45|
647 forum posts
Where would I be without your help Michael?
I've removed my dark glasses, and can hear much better.
Please login to post a reply.
Want the latest issue of Model Engineer or Model Engineers' Workshop? Use our magazine locator links to find your nearest stockist!
You can contact us by phone, mail or email about the magazines including becoming a contributor, submitting reader's letters or making queries about articles. You can also get in touch about this website, advertising or other general issues.
Click THIS LINK for full contact details.
For subscription issues please see THIS LINK.